D-Link DGS-3120-48PC - Page 673

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
669
Example
To configure the sending of linkchange traps:
DGS-3120-24TC:admin# config snmp linkchange_traps ports 1:1-1:4 enable
Command: config snmp linkchange_traps ports 1:1-1:4 enable
Success.
DGS-3120-24TC:admin#
72-31 config snmp coldstart_traps
Description
This command is used to configure the trap for coldstart event.
Format
config snmp coldstart_traps [enable | disable]
Parameters
enable - Enable the trap of the coldstart event. The default state is enabled.
disable - Disable the trap of the coldstart event.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure the trap for coldstart event:
DGS-3120-24TC:admin# config snmp coldstart_traps enable
Command: config snmp coldstart_traps enable
Success.
DGS-3120-24TC:admin#
72-32 config snmp warmstart_traps
Description
This command is used to configure the trap state for warmstart event.
Format
config snmp warmstart_traps [enable | disable]