xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
668
72-29 disable snmp linkchange_traps
Description
This command is used to configure the sending of linkchange traps.
Format
disable snmp linkchange_traps
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To disable the sending of linkchange traps:
DGS-3120-24TC:admin# disable snmp linkchange_traps
Command: disable snmp linkchange_traps
Success.
72-30 config snmp linkchange_traps ports
Description
This command is used to configure the sending of linkchange traps and per port control for
sending of change trap.
Format
config snmp l
inkchange_traps por
ts [all | <portlist>] [enable | disabl
e]
Parameters
all - To specify all ports.
<portlist> - To specify a port range.
enable - Enable sending of the link change trap for this port.
disable - Disable sending of the link change trap for this port.
Restrictions
Only Administrator and Operator-level users can issue this command.
To Next Page
Loading...
