D-Link DGS-3120-48PC - Show Ipv6 Nd

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
368
Example
To configure the retrans_time of IPv6 ND neighbor solicitation:
DGS-3120-24TC:admin# config ipv6 nd ns ipif Zira retrans_time 1000000
Command: config ipv6 nd ns ipif Zira retrans_time 1000000
Success.
DGS-3120-24TC:admin#
35-5 show ipv6 nd
Description
This command is used to display information regarding neighbor detection on the Switch.
Format
show ipv6 nd {ipif <ipif_name 12>}
Parameters
ipif – (Optional) The name of the interface.
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters
long.
If no IP interface is specified, it will show the IPv6 ND related configuration of all interfaces.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To show IPv6 ND related configuration:
DGS-3120-24TC:admin#show ipv6 nd ipif System
Command: show ipv6 nd ipif System
Interface Name : System
NS Retransmit Time : 0 (ms)
DGS-3120-24TC:admin#