D-Link DGS-3120-48PC - Config Stp Priority

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
509
Format
show stp ports {<portlist>}
Parameters
ports - To show parameters of the designated port numbers, to be distinguished from showing
parameters of the bridge.
<portlist> - (Optional) Enter a list of ports used for the configuration here.
Restrictions
None.
Example
To show STP ports:
DGS-3120-24TC:admin#show stp ports
Command: show stp ports
MSTP Port Information
----------------------
Port Index : 1:1 , Hello Time: 2 /2 , Port STP : Enabled ,
External PathCost : Auto/200000 , Edge Port : False/No , P2P : Auto /Yes
Port RestrictedRole : False, Port RestrictedTCN : False
Port Forward BPDU : Disabled
MSTI Designated Bridge Internal PathCost Prio Status Role
----- ------------------ ----------------- ---- ---------- ----------
0 N/A 200000 128 Disabled Disabled
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
50-13 config stp priority
Description
This command is used to configure the instance priority.
Format
config stp priority <value 0-61440> instance_id <value 0-15>
Parameters
priority - Specify the bridge priority value. This value must be divisible by 4096.
<value 0-61440> - Enter the bridge priority value here. This value must be between 0 and
61440.
instance_id - Identifier to distinguish different STP instances.
<value 0-15> - Enter the STP instance ID here. This value must be between 0 and 15.