xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
80
Example
To configure a TACACS+ authentication server host’s key value:
DGS-3120-24TC:admin#config authen server_host 10.1.1.222 protocol tacacs+ key
"This is a secret."
Command: config authen server_host 10.1.1.222 protocol tacacs+ key "This is a
secret."
Success.
DGS-3120-24TC:admin#
5-22 delete authen server_host
Description
This command is used to delete an authentication server host.
Format
delete authen server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius]
Parameters
<ipaddr> - Enter the server host's IP address.
- Specify that server host's authentication protocol.
tacacs - Server host’s authentication protocol.
xtacacs - Server host’s authentication protocol.
tacacs+ - Server host’s authentication protocol.
radius - Server host’s authentication protocol.
Restrictions
Only Administrator-level users can issue this command.
Example
To delete an authentication server host:
DGS-3120-24TC:admin# delete authen server_host 10.1.1.222 protocol tacacs+
Command: delete authen server_host 10.1.1.222 protocol tacacs+
Success.
5-23 show authen server_host
Description
This command is used to display the authentication server hosts.
To Next Page
Loading...
