D-Link DWC-2000 User Manual 112
Section 4 - Advanced WLAN Conguration
After the download begins, the AP Firmware Status tab will display information about the upgrade. Refer to the
table below:
Field Description
Code Download Status
Status (Global)
The status of the upgrade process for all APs:
• Not Started: The wireless controller has not started the download process.
• Requested: A request to download AP software has been made, but the controller
has not done any downloads.
• Code Transfer in Progress: A download is in progress.
• Failure: Download failed on all APs.
• Aborted: Download was aborted before the AP loaded code from the TFTP
server.
• NVRAM‐Update‐in‐Progress: Download completed successfully. The reset
command has been sent to the AP.
• Success: All APs are connected to the wireless controller.
Download Count
The number of managed APs to download software in the current download request.
If you selected All for the managed APs to upgrade, the download count shows the
number of managed APs at the time the download request was started. The value is
1 if only one AP is being updated.
Success Count
The number of APs that have successfully downloaded the new code. This value
starts with 0 at the beginning of the download and increases by one for every AP that
successfully downloaded the code.
Failure Count
The number of APs that failed to download the new code starting at 0 and incremental
with each failure.
Abort Count
The number of APs for which the download was aborted, starting at 0 and incremental
each aborted download.
Path: Maintenance > Firmware > AP Firmware Download > AP Firmware Status
To Next Page
Loading...
Need help?
General
Weight and Dimensions
