Daedong EX50-SA - Page 92

EX50-SA / EX55-SA / EX5310-AU / EX5810-AU
4
-
38
For detailed information on installa-
tion, contact your local
KIOTI
Dealer.
(1) Rear Weight (2) Weight Bolt
(3) Nut (4) Spring Washer
(5) Bolt
Max. load
25kg X 5 Pieces (275lbs)
•
Attach only required amount
of weight.
•
Unnecessary weight can result
in poor braking performance,
rapid wear of the brake disc,
shortened axle life, and in-
crease in fuel consumption.
IMPORTANT
H11O4E2B
It is possible to inject water and cal-
cium solution into the tire to use it as
a ballast.
If one liter of water is mixed with 0.4
kg of calcium, this liquid does not
freeze down at -49 ° F (-45 ° C).
For a tire without a tube, fill it with
water and calcium solution at least to
the valve stem level (75%) with the
valve stem.
If the tire without a tube is not lled
withwaterandcalciumsolutionsuf-
ciently, a part of the ream is exposed,
resulting in corrosion.
Foratirewithatube,llitupto90%
of its level.
ADDITIONAL LIQUID TYPE WEIGHT
•
The liquid injection should be
performed only by a qualified
service personnel.
•
For detailed information, contact
your local
KIOTI
Dealer.
NOTE
•
Iftheliquidballastisused,inate
the tire 0.14 bar (2 psi) more
thanthespeciedpressure.This
is to compensate for the ventila-
tion symptom which occurs while
the tire is moving.
NOTE
TE150 (EX50, EX55)-���-04.indd 38 2019-03-19 �� 6:58:37