345
Figure 4-129
Input user name and password to set iSCSI path access right.
There are two situations:
When you set the iSCSI server, you have set corresponding user name or password for a path. In
this situation, you need to input user name or password to login.
When you set the iSCSI server, you have not set the corresponding access right. In this situation,
you can check the anonymous button or input customized user name.
Click add button, now you have added an iSCSI server. Click OK button, the setup is finish. The interface
is shown as in Figure 4-130.
Note:
If you have not input a user name/password, or check the anonymous button, system pops up a
dialogue box to prompt you that system is going to add anonymously. In this situation, once the
iSCSI path has the access setup, you may not connect to the iSCSI server.
Since the connection may take a while, please wait a moment and then click refresh button, once the
status is shown as offline after you added.
Figure 4-130
To Next Page
Loading...
Need help?
General
