Dalsa Linea Lite GigE Series User Manual

Linea Lite GigE Series Camera Technical Specifications • 151
External Output Details
• The output signals can be used in programmable output mode such as strobe, event
notification, etc. (See Output Line Source
feature).
• For the Single-Ended Open Collector outputs, the user supplied pull-up resistor value should
be between 1 kΩ and 10 kΩ depending on supply rail. Resistor Wattage should be calculated
accordingly.
• Outputs are open (disabled) on power-up with the default factory settings.
• A software reset will not reset the outputs to the open state if the outputs are active.
• A user setup configured to load on boot will not reset the outputs to the open state if the
outputs are active.
• The output signals are designed to prevent an output signal glitch on power-up or polarity
reversal.
• Protection Circuit – DC Ratings:
• Output protected against shorts to ground or other voltages
• Output maximum voltage of 26 V at 10 mA (at 60°C)

Dalsa Linea Lite GigE Series Specifications

General

Brand	Dalsa
Model	Linea Lite GigE Series
Category	Digital Camera
Language	English