DataCard SD Series

SD Series Card Printer User’s Guide A-15
5.
Inspectthelaminatorcartridgesforparticles.Ifparticlesarepresent:
A. Retrievethelaminatorcleaningcardfromtheoutputhopperanduseitto
removetheparticlesofoverlaymat erialfromthecartridges.
B. Ifparticlesstillremainonthecartridgeandinsideofthelaminator, usea
vacuumcleanerwithasmallplastichoseattachmenttocarefullyremove
theparticles.Alsocleananyremainingparticlesfromtheoutputhopper.
HINTS&TIPS
• Ifthecleaningcardisnotpulledinto thelaminator,thecardisnotinthe
correctposition.Thecleaningcardmustbelocatedundertherollersofthe
cardexitslotinsidetheoutputhopper.
• Attheendofthelaminatorcleaningcycle,thecardcansticktotherollersin
theoutputhopper.Pullgentlyonthecardtoremoveit.
• Discardthelaminatorcleaningcardafteroneuse.
• Ifcleaningthelaminatordoesnotsolvetheproblem,contactyourservice
providerforassistance.