DataCard SD Series

SD Series Card Printers User’s Guide 19
Load and Replace Supplies
Topreparetheprintertoprintcards,loadblankcardstockintotheinputhopper
(optional),andloadprintribbonandacleaningsleeveontotheprint cartridge.If
youareusinganSD460system,alsoloadoverlaymaterialintotheL1andL2(if
equipped)laminatorcartridges.RefertoAppendixA,"Load LaminatorOverlay
Materia l"onpa ge A‐8,forinformationaboutloadingthelaminatorcartridges.
Load Cards
Ifyouareusingamanualfeedprinter,skipthisstepandkeepasupplyofblank
cardsclosetotheprinter.
Forprinterswithaninputhopper,do
thefollowing:
1. Opentheinputhopper.
2. Loadthecardsintotheinput
hopper.(Cardscansticktogether.
Slideorfanthecardstoseparate
theedgesbeforeplacingthemin
theinputhopper.)
• InsertISOmagneticstripe
cardswiththestripe(back
side)facingdownandtothe
right.
• Insertsmartcardswiththesmartcardchipfacingupandtowardtheback
ofthehopper.
3. Closetheinputhopper.