DataCard SD Series

72 Troubleshooting
202: L1 supply out or missing
Thelaminatordoesnothaveusablesupplies.
1. Openthelaminator.
2. Replacethesupply.
3. Closethelaminator.
203: L1 supply type problem
Thelaminatorcannotusethesupplyinstalled.
Usesuppliesdesignedforthislaminator.
204: L1 supply not supported
Thelaminatorcannotusethesupplyinstalled.
Usesuppliesdesignedforthislaminator.
205: L1 supply not identified
Thelaminatorcannotusethesupplyinstalled.
Usesuppliesdesignedforthislaminator.
206: L2 supply problem
TheL2supplyisnotmovingproperly.Totryanothercard:
1. OpenthelaminatorandremovetheL2cartridge.
2. Reposition,repair,orreplacethesupplyandadvancetherepairedareaone
fullturn.
3. Replacethecartridgeandclosethelaminator.
207: L2 supply out or missing
Thelaminatordoesnothaveusablesupplies.
1. Openthelaminator.
2. Replacethesupply.
3. Closethelaminator.