DataCard SD Series

68 Troubleshooting
121: Print ribbon not identified
Theprintercannotusetheribboninstalled.Thecardwillbecanceled.
Useribbondesignedforthisprinter.
PresstheUSERbuttonontheprinter,orclickOKinthemessageboxtoclearthe
message.
HINTS&TIPS
Askyourdealerorauthorizedresellerforareplacementribbon.
122: Magstripe format problem
Themagneticstripedatasentdoesnotmatchtheformatsetintheprinter.The
cardwillbecanceled.
PresstheUSERbuttonontheprinter,orclickOKinthemessageboxtoclearthe
message.
123: Insert new card side 1 up
1. Insertanewcardintheprinterwithside1facingup.
2. Ifthecardisnotimmediatelypicked,presstheprinter’sUSERbuttonor
clickOK.
ClickCancelinthemessageboxifyouwanttocancelthecard.
124: Insert same card side 2 up
1. Takethe cardfromtheprinter.
2. Turnthecardoverendtoendsoside2isfacingup.
3. Insertthecardintheprinter.
4. Ifthecardisnotimmediatelypicked,presstheprinter’sUSERbuttonor
clickOK.
ClickCancelinthemessageboxifyouwanttocancelthecard.