DataCard SD260

65
Chapter 4: Printing Cards
This section explains how to:
• Print a card to a printer with an input hopper. See “Printing Cards: Printer
with In
put Hopper” for details.
• Print a card to a printer with
a single feed slot. See “Printing Cards: Printer
with Single Feed Slot” for details.
• Print on both sides of a card. See “Print
on Both Sides of the Card” for
details.
• Print a sample card. “Print Driver Sample
Cards” for details.
Make sure:
• The printer system is set up. See “Printer System
” for details.
• The card design is set up. See “Card Desi
gn and Setup” if you need to set up
the design.
• Rib
bon is loaded in the printer. See “Load Ribbon”
for the steps to follow.
H
INTS & TIPS
Make sure magnetic stripe cards are inserted correctly. The printer shows the
correct position.
You can also print a test card from the printer. See “Print a Printer Test Card”.