Datalogic Gryphon I GBT4400 - Wireless Beeper Features; Beep Frequency; Good Transmission Beep

Enter/Exit Programming Mode Wireless Beeper Features
234 Gryphon™ I GD44XX / GBT4400/GM440X
Wireless Beeper Features
Several options are available to configure beeper behavior for RF operation.
Good Transmission Beep
Enables/disables the Good Transmission Beep indication. When enabled, a beep occurs when a
Label is correctly transmitted to the base.
Beep Frequency
Adjusts radio-specific beep indications to sound at a low, medium or high frequency, selectable
from the list below (controls the beeper’s pitch/tone).
Good Transmission Beep = Disable
Good Transmission Beep = Enable
$CBTAB00(CR)
$CBTAB01(CR)
DEFAULT
Beep Frequency = Low
Beep Frequency = Medium
Beep Frequency = High
DEFAULT
$CBTBF00(CR)
$CBTBF01(CR)
$CBTBF02(CR)