Datalogic Gryphon I GBT4400 - Led and Beeper Indicators; Good Read: When to Indicate; Power on Alert

Enter/Exit Programming Mode Reading Parameters
92 Gryphon™ I GD44XX / GBT4400/GM440X
LED AND BEEPER INDICATORS
Power On Alert
Disables or enables the indication (from the Beeper) that the reader is receiving power.
Good Read: When to Indicate
This feature specifies when the reader will provide indication (beep and/or flash its green LED)
upon successfully reading a bar code.
Power On Alert = Disable (No Audible Indication)
Power On Alert = Power-up Beep
$CBPPU00(CR)
$CBPPU01(CR)
DEFAULT
Indicate Good Read = After Decode
Indicate Good Read = After Transmit
Indicate Good Read =
A
fter CTS goes inactive then active
DEFAULT
$CBPIN00(CR)
$CBPIN01(CR)
$CBPIN02(CR)