Datalogic Laser Sentinel User Manual

DIAGNOSTICS
92 SAFERY LASER SCANNER
ENC ERROR LOCKOUT OFF
This error can occur
if one of the
following conditions is met:
•The difference between the speed
measur
es collected by Encoder 1
and Encoder 2 exceeds the
Encoder Δ beyond the allowable
time window.
•The encoders are not connected
pr
operly.
SLAVE ERROR LOCKOUT OFF
The Master device warns against a
fault
or error condition in a Slave
unit.
EDM LOCKOUT OFF
EDM error. Check the connection of
the
EDM wire and verify if the set-
ting of the delay match with the
char
acteristics of the relay then, if
necessary, replace the relay.
If the error persist, contact Data-
logic Technical Support.
MG NO MATCHING BOOT OFF
Memory Group does not match with
the confi
guration. Replace the
Memory Group with the right
model.
MG FAILURE BOOT OFF
Memory Group failure. Create a new
configur
ation via GUI, perform a
backup configuration from the Mas-
ter device, or replace the Memory
Gr
oup.
MG EMPTY BOOT OFF
The Memory Group has no configu-
ration stored on board. Create a
ne
w configuration via GUI or per-
form a backup configuration from
the Master
device.
DEVICE EMPTY BOOT OFF
The Master device has no configu-
ration stored on board. Create a
ne
w configuration from GUI or
restore the configuration from the
Memory Group.
CFG NO MATCHING BOOT OFF
The device configuration does not
match with the
Memory Group con-
figuration. Follow the displayed
instructions.
INCOHERENCE BOOT OFF
The device found an incoherent
configuration. A new configuration
via GUI is necessary.
DISPLAYED
ICON
DISPLAYED
FAULT CODE
DEVICE
STATUS
OSSD
STATUS
DESCRIPTION

Datalogic Laser Sentinel Specifications

General

Brand	Datalogic
Model	Laser Sentinel
Category	Scanner
Language	English