AGC Designer’s Reference Handbook
DEIF A/S Page 108 of 168
Input function selection
Digital input alarms can be configured with a possibility to select when the alarms are to be
activated. The possible selections of the input function are normally open or normally closed.
The drawing below illustrates a digital input used as an alarm input.
1. Digital input alarm configured to NC, normally closed
This will initiate an alarm when the signal on the digital input disappears.
2. Digital input alarm configured to NO, normally open
This will initiate an alarm when the signal on the digital input appears.
Language selection
The unit has the possibility to display different languages. It is delivered with one master
language which is English. This is the default language, and it cannot be changed. In addition to
the master language 11 different languages can be configured. This is done via the PC utility
software.
The languages are selected in the system setup
(
The
alarm is for the auxiliary power supply measured on terminals 1 and 2.
6130 Language
The language can be changed when connected to the PC utility software. It is not possible to
make language configuration from the display, but the already configured languages can be
selected.
Buttons used in the PC utility software
Retrieve languages from the device:
Activating this button will retrieve the configured languages from the device.
Send languages to the device:
Activating this button will send the content of the 11 language frames to the device.
The relay output function cannot be changed. This will always be a NO relay and
will close when the alarm occurs, alarm = CC (closed contact).
D i g in
Com
Relay out
AGC
+
V DC
Alarm
input
To Next Page
Loading...
Need help?
General
