Deif Multi-line 2 User Manual

AGC Designer’s Reference Handbook
DEIF A/S Page 79 of 168
Input name Input status Comment
Fire pump Active
Access lock
Running feedback Active
Remote start Not active
Remote stop Not active
Semi-auto Not active
Test Not active
Auto Not active
Manual Not active
Block Not active
Remote GB ON Not active
Remote GB OFF Not active
Remote MB ON Not active
Remote MB OFF Not active
Remote TB ON Not active
Remote TB OFF Not active
Remote alarm acknowledge Active
Gen-set start sequence Active
Remove starter Active
Reset analogue governor output Active
Manual GOV up Active
Manual GOV down Active
Manual AVR up Active
Manual AVR down Active
Alarm inhibit Active
GB position ON Active
GB position OFF Active
MB position ON Active
MB position OFF Active
Emergency stop Active
External engine failure Active
AOP buttons Active
Short-time parallel
The purpose of the short time parallel function is to be able to define a maximum paralleling time
between the generator and the mains supply.
The function is typically used, if there are local requirements to maximum allowed paralleling
time.
The short time paralleling function is only available in the automatic mains
failure and load take over gen-set modes.

Deif Multi-line 2 Specifications

General

Brand	Deif
Model	Multi-line 2
Category	Controller
Language	English