AGC Designer’s Reference Handbook
DEIF A/S Page 82 of 168
Running output
6150 Running status
can be adjusted to give a digital output when the gen-set is running.
Select the correct relay number in output A and output B and enable the function. Change the
relay function to limit in the I/O menu. Then the relay will activate, but no alarm will appear.
Derate gen-set
The purpose of the derate function is to be able to reduce the maximum output power of the
gen-set, if specific conditions require this. An example of such a condition is the ambient
It is necessary to use the PC utility software when setting up the time dependent
start/stop function.
If the relay function is not changed to ‘limit’ function, an alarm will appear at
every running situation.
To Next Page
Loading...
