AGC Designer’s Reference Handbook
DEIF A/S Page 168 of 168
6510 Daytime period
The period outside the daytime period is defined as the nighttime period.
No. Setting Min. setting Max. setting Factory
setting
6511 Daytime period Start hour 0 h 23 h 8 h
6512 Daytime period Start minute 0 min 59 min 0 min
6513 Daytime period Stop hour 0 h 23 h 16 h
6514 Daytime period Stop minute 0 min 59 min 0 min
6520 Start gen-set
The setpoint refers to the mains power setpoints in 6500 Mains power
.
No. Setting Min. setting Max. setting Factory
setting
6521 Start generator Setpoint 5% 100% 80%
6522 Start generator Timer 0.0 s 990.0 s 10.0 s
6523 Start generator Minimum load 0% 100% 5%
6530 Stop gen-set
The setpoint refers to the mains power setpoints in 6500 Mains power
.
No. Setting Min. setting Max. setting Factory
setting
6531 Stop generator Setpoint 0% 80% 60%
6532 Stop generator Timer 0.0 s 990.0 s 30.0 s
6540 Test running
No. Setting Min. setting Max. setting Factory
setting
6541 Test Setpoint 1% 100% 80%
6542 Test Timer 0.5 min 999.0 min 5.0 min
6543 Test Return Semi-auto Auto Auto
6550 Fixed power setpoint
No. Setting Min. setting Max. setting Factory
setting
6551 Fixed power setpoint P setpoint 0% 100% 100%
6590 Mains failure voltage
No. Setting Min. setting Max. setting Factory
setting
6591 Mains failure U Fail. delay 1.0 s 990.0 s 5.0 s
6592 Mains failure U Mains OK delay 10 s 9900 s 60 s
6593 Mains failure U Low voltage 80% 100% 90%
6594 Mains failure U High voltage 100% 120% 110%
6595 Mains failure U Mains fail. control Start eng. +
open MB
Start eng. Start eng. +
open MB
Transducer max. equals 20mA, and Transducer min. equals 4mA. Both settings
must be adjusted.
To Next Page
Loading...
