Deif Multi-line 2 User Manual

AGC Designer’s Reference Handbook
DEIF A/S Page 148 of 168
Overview list
Protection
4310 Overspeed 1 p. 158
1010 Reverse power p. 148 4320 Overspeed 2 p. 158
1020 Overcurrent 1 p. 148 4370 Wire failure analogue input 98 p. 158
1030 Overcurrent 2 p. 148 4380 Wire failure analogue input 100 p. 158
4390 Wire failure analogue input 102 p. 158
Control
4400 Wire failure analogue input 104 p. 158
4410 Wire failure VDO input 104 p. 159
Synchronisation 4410 Wire failure PT100 input 106 p. 159
2010 Synchronisation type p. 148 4420 Wire failure VDO input 105 p. 159
2020 Dynamic synchronisation p. 149 4420 Wire failure PT100 input 109 p. 159
2030 Static synchronisation p. 149 4430 Wire failure VDO input 106 (M2) p. 159
2040 Sync. blackout p. 149
2070 GB general failure p. 149 Output setup
2080 MB general failure p. 149 5090 Relay 9 p. 160
2090 Breaker failure alarms p. 150 5100 Relay 10 p. 160
2100 Separate synchronisation relay p. 150 5110 Relay 11 p. 160
2110 Close before excitation p. 150 5120 Relay 12 p. 160
2120 Breaker sequence p. 150 5130 Relay 13 p. 160
2130 Excitation failure p. 150 5490 Transistor setup p. 160
Regulation
System
2510 Frequency controller p. 151
2520 Power controller p. 151 General setup
2530 Power ramp-up p. 151 6010 Nominal settings p. 161
2540 Power ramp-down p. 151 6020 Nominal settings 2 p. 161
2560 Governor regulation failure p. 151 6030 Transformer gen. p. 161
2640 Relay control p. 152 6040 Transformer bus. p. 161
2690 Delay regulation p. 152 6050 Engine type p. 161
2700 Short-time paralleling p. 152 6060 Gen-set modes p. 162
6070 Date and time (internal clock) setting p. 162
Input/output
6080 Counters p. 162
6090 Service timer p. 162
Binary input setup 6110 Battery low voltage alarm p. 163
3260 Dig. input no. 110 (Option M2) p. 152 6120 Battery high voltage alarm p. 163
3270 Dig. input no. 111 (Option M2) p. 152 6130 Language p. 163
3280 Dig. input no. 112 (Option M2) p. 153 6140 Alarm horn p. 163
3290 Dig. input no. 113 (Option M2) p. 153 6150 Running status p. 163
3300 Access lock (binary input 114) p. 153 6160 Remove starter p. 163
3310 Running feedback (binary input 115) p. 153 6170 Starter p. 164
3320 Ext. engine failure (binary input 116) p. 153 6180 Start attemps p. 164
3330 Ext. emergency stop (binary input 117) p. 154 6190 f/U OK p. 164
3340 Dig. input no. 118 p. 154 6200 f/U failure p. 164
6210 Stop p. 164
Analogue input setup 6220 Stop failure p. 164
4090 4...20mA input 98.1 p. 154 6250 GB control p. 164
4100 4...20mA input 98.2 p. 154 6260 Pnom derate p. 165
4110 Oil pressure 1 p. 155 6310 Idle running p. 165
4120 Oil pressure 2 p. 155 6400 Master clock p. 165
4130 Fuel level 1 p. 155 6410 Battery test p. 165
4140 Fuel level 2 p. 155 6420 Voltage trip p. 165
4150 4...20mA input 104.1 p. 155
4160 4...20mA input 104.2 p. 156 Mains setup
4170 VDO 104.1 (Option M2) p. 156 6500 Mains power p. 165
4180 VDO 104.2 (Option M2) p. 156 6510 Daytime period p. 166
4190 VDO 105.1 (Option M2) p. 156 6520 Start gen-set p. 166
4200 VDO 105.2 (Option M2) p. 156 6530 Stop gen-set p. 166
4210 VDO 106.1 (Option M2) p. 157 6540 Test running p. 166
4220 VDO 106.2 (Option M2) p. 157 6550 Fixed power set point p. 166
4240 Water temperature p. 157 6590 Mains failure voltage p. 166
4260 PT100 input 109.1 p. 157 6600 Mains failure frequency p. 167
4300 Running detection p. 157 6610 Mains breaker control p. 167

Deif Multi-line 2 Specifications

General

Brand	Deif
Model	Multi-line 2
Category	Controller
Language	English