Operator info Additional information
SGB close blocked
The Block SGB close function is active. An open breaker
cannot be closed.
●
SGB close cancelled The SGB close was cancelled by a SGB open command. ●
SGB close not possible in
SWBD
While the controller is under switchboard control, operator
actions cannot be performed from the controller
interfaces.
●
SGB close unblocked The Block SGB close function is not active. ●
SGB open cancelled The SGB open was cancelled by a SGB close command. ●
SGB open not possible in
SWBD
While the controller is under switchboard controller,
operator actions cannot be performed from the controller
interfaces.
●
Start enable not activated
The genset cannot start, because Start enable is not
activated.
●
Static synchronisation
activated
The digital input is activated. The controller will use static
synchronisation.
● ● ● ●
Static synchronisation
deactivated
The digital input is deactivated. The controller will use the
synchronisation type configured in the parameter.
● ● ● ●
Synchronisation cancelled
The controller has cancelled the synchronisation (for
example, if there is a blackout during synchronisation).
●
OPERATOR'S MANUAL 4189341099G UK Page 14 of 130
To Next Page
Loading...
