Operator info Additional information
Engine start not possible in
SWBD
While the controller is under switchboard control, operator
actions cannot be performed from the controller
interfaces.
●
Engine start unblocked The Block engine start function is not active. ●
Engine stop not possible in
SWBD
While the controller is under switchboard control, operator
actions cannot be performed from the controller
interfaces.
●
GB close blocked
The Block GB close function is active. An open breaker
cannot be closed.
●
GB close not possible in
SWBD
While the controller is under switchboard control, operator
actions cannot be performed from the controller
interfaces.
●
GB close cancelled The GB close was cancelled by a GB open command. ●
GB close not possible in
SWBD
While the controller is under switchboard control, operator
actions cannot be performed from the controller
interfaces.
●
GB close unblocked The Block GB close function is not active. ●
GB is closed The Generator breaker is closed. ●
GB is de-loading The Generator breaker is currently de-loading. ●
GB is open The Generator breaker is open. ●
GB is synchronising The Generator breaker is synchronising. ●
GB open and stop not
possible in SWBD
While the controller is under switchboard control, operator
actions cannot be performed from the controller
interfaces.
●
GB open cancelled The GB open was cancelled by a GB close command. ●
GB open not possible in
SWBD
While the controller is under switchboard control, operator
actions cannot be performed from the controller
interfaces.
●
Mode change locked
It is not possible to change to REMOTE or LOCAL mode
while the controller is under switchboard control.
● ● ● ●
Not under local control
The action cannot be performed unless the controller is in
LOCAL mode.
● ● ● ●
You can remove latches
There are acknowledged latched alarms in the alarm list
that can be reset.
● ● ● ●
SCB close blocked
The Block SCB close function is active. An open breaker
cannot be closed.
●
SCB close cancelled The SCB close was cancelled by a SCB open command. ●
SCB close not possible in
SWBD
While the controller is under switchboard control, operator
actions cannot be performed from the controller
interfaces.
●
SCB close unblocked The Block SCB close function is not active. ●
SCB open cancelled The SCB open was cancelled by a SCB close command. ●
SCB open not possible in
SWBD
While the controller is under switchboard controller,
operator actions cannot be performed from the controller
interfaces.
●
OPERATOR'S MANUAL 4189341099G UK Page 13 of 130
To Next Page
Loading...
