Click OK .5.
If this is a new printer, you may be prompted to install a printer driver. If no system driver is
available, then you will need to provide a path to available drivers
Select whether you want this printer to be the default printer for the client, and then click Finish .6.
Print a test page to verify printer installation.7.
When a test page prints successfully, printer installation is complete.
To print a test page:
For Windows 2000, click the Start button Settings Printer .1.
For Windows XP/Server 2003, click the Start button and point to Printers and Faxes .
For Windows Vista/Server 2008, click the Start button and click Control Panel Hardware and
Sound Printers .
For Windows 7, click the Start button and click Control Panel Hardware and Sound Devices
and Printers .
For Windows Server 2008 R2, click the Start button and click Control Panel Hardware
Devices and Printers .
Double-click your printer icon.2.
Click the File menu and point to Properties .3.
Click the General tab, and select Print Test Page .4.
Setting Up a Network-connected Printer
You must set up the network protocols on the printer to use it as your network printer. Protocols can be set
up by the following two methods:
1 Via Network Administration Programs
You can configure your printer's print server settings and manage it via the following programs:
Set IP Address Utility : A utility program allowing you to find your network printer and manually
configure the addresses for use with the TCP/IP protocol.
Embedded Web Service : A web server embedded to your network print server, which allows you to:
Configure the network parameters necessary for the printer to connect to various network
environments.
2 Via the Operator Panel
To Next Page
Loading...
