Daylight Savings Time and to Standard time.
Press Scroll ( or ) to highlight Setup and then press Select ( ).1.
Press Scroll ( or ) to highlight Machine Setup and then press Select ( ).2.
Press Scroll ( or ) to highlight Day Light Saving and then press Select ( ).3.
Press Scroll ( or ) to highlight Manual and then press Select ( ).4.
Enter Start Date and then press Select ( ).5.
Enter End Date and then press Select ( ).6.
Press Cancel ( ) to return to the Standby mode.7.
Scanner Lamp Power Save Mode
The scan lamp under the document glass automatically turns off when it is not in actual use after a preset
period to reduce power consumption and extend the lamp life. The lamp automatically turns on and the
warm-up cycle begins whenever any key is pressed or the DADF cover is opened or a document is detected
in the DADF.
You can set the duration for which the scan lamp waits after a scan job is completed before it switches to the
Power Save mode.
Press Scroll ( or ) to highlight Setup and then press Select ( ).1.
Press Scroll ( or ) to highlight Machine Setup and then press Select ( ).2.
Press Scroll ( or ) to highlight Scan Power Save and then press Select ( ).3.
Press Scroll ( or ) to display the time settings you want.4.
The available time options are 30, 60, and 120 (minutes).
Press Select ( ) to save the selection.5.
Press Cancel ( ) to return to the Standby mode.6.
To Next Page
Loading...
