Dell 2335dn - Restoring the Network Configuration

7.
An IP address consists of 4 bytes.
Enter the numbers from the keypad and use Scroll ( or ) to move between octets and then
press Select ( ).
8.
Enter other parameters, such as the Subnet Mask or Gateway , and then press Select (
).
9.
After entering all parameters, press Cancel ( ) to return to the Standby mode.10.
Dynamic Addressing (BOOTP/DHCP)
To assign the TCP/IP address automatically using a DHCP or BOOTP server on your network.
Press Scroll ( or ) to highlight Setup and then press Select ( ).1.
Press Scroll ( or ) to highlight Network Setup and then press Select ( ).2.
Press Scroll ( or ) to highlight TCP/IP (IPv4) and then press Select ( ).3.
Press Scroll ( or ) to highlight Set IP Address and then press Select ( ).4.
Press Scroll ( or ) to highlight DHCP and then press Select ( ).5.
To assign the address from the BOOTP server, press Select ( ) when BOOTP displays.
Restoring the Network Configuration
You can return the network configuration to its default settings.
Press Scroll ( or ) to highlight Setup and then press Select ( ).1.
Press Scroll ( or ) to highlight Network Setup and then press Select ( ).2.
Press Scroll ( or ) to highlight Clear Settings and then press Select ( ).3.
Press Scroll ( or ) to highlight Yes and then press Select ( ) to restore the
network configuration.
4.
Power the printer off and back on or reset the network interface card.5.
Downloaded from ManualsPrinter.com Manuals