Dell 2335dn - Connecting the printer to the Network; Powering On the Printer

2.
Connect the other end of the cable to an available USB port on the computer, not the USB keyboard.3.
Connecting the printer to the Network
Ensure that the printer, computer, and any other attached devices are powered off and unplugged.1.
Connect one end of a standard category 5 Unshielded Twisted Pair (UTP) network cable to a LAN drop
or hub, and the other end to the Ethernet network port on the back of the printer. The printer
automatically adjusts for the network speed.
2.
NOTE: After connecting the printer, you need to configure the network parameters on the operator
panel. See "Printing a Network Configuration Page" .
Powering On the Printer
CAUTION: The fusing area at the rear part of the inside of your printer becomes hot once
the printer is powered on.
CAUTION: Be careful not to be burned when you access this area.
Downloaded from ManualsPrinter.com Manuals