4 0 0
5 0 0
6 0 0
7 0 0
The following example shows the show interface ets summary command.
Dell(conf-qos-policy-out-ets)#do sho int te 1/3 ets su
Interface TenGigabitEthernet 1/3
Max Supported TC Groups is 4
Number of Traffic Classes is 8
Admin mode is on
Admin Parameters :
------------------
Admin is enabled
TC-grp Priority# Bandwidth TSA
------------------------------------------------
0 - -
1 0,1,2 100% ETS
2 3 0 % SP
3 4,5,6,7 0 % SP
4 - -
5 - -
6 - -
7 - -
Remote Parameters :
-------------------
Remote is disabled
Local Parameters :
------------------
Local is enabled
TC-grp Priority# Bandwidth TSA
------------------------------------------------
0 - -
1 0,1,2 100% ETS
2 3 0 % SP
3 4,5,6,7 0 % SP
4 - -
5 - -
6 - -
7 - -
Oper status is init
ETS DCBx Oper status is Down
State Machine Type is Asymmetric
Conf TLV Tx Status is enabled
Reco TLV Tx Status is enabled
0 Input Conf TLV Pkts, 1955 Output Conf TLV Pkts, 0 Error Conf TLV Pkts
0 Input Reco TLV Pkts, 1955 Output Reco TLV Pkts, 0 Error Reco TLV Pkts
Dell(conf)# show interfaces tengigabitethernet 1/1 ets detail
Interface TenGigabitEthernet 1/1
Max Supported TC Groups is 4
Number of Traffic Classes is 8
Admin mode is on
Admin Parameters :
------------------
Data Center Bridging (DCB)
319
To Next Page
Loading...
