EasyManuals Logo

Dell S4820T User Manual

Dell S4820T
1178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #820 background imageLoading...
Page #820 background image
To apply a Layer 2 policy on a Layer 3 interface:
1. Configure an interface with an IP address or a VLAN sub-interface
CONFIGURATION mode
Dell(conf)# interface fo 1/4
INTERFACE mode
Dell(conf-if-fo-1/4)# ip address 90.1.1.1/16
2. Configure a Layer 2 QoS policy with Layer 2 (Dot1p or source MAC-based) match criteria.
CONFIGURATION mode
Dell(conf)# policy-map-input l2p layer2
3. Apply the Layer 2 policy on a Layer 3 interface.
INTERFACE mode
Dell(conf-if-fo-1/4)# service-policy input l2p layer2
Applying DSCP and VLAN Match Criteria on a Service Queue
You can configure Layer 3 class maps which contain both a Layer 3 Differentiated Services Code Point
(DSCP) and IP VLAN IDs as match criteria to filter incoming packets on a service queue on the switch.
To configure a Layer 3 class map to classify traffic according to both an IP VLAN ID and DSCP value, use
the match ip vlan vlan-id command in class-map input configuration mode. You can include the
class map in a policy map, and apply the class and policy map to a service queue using the
service-
queue command. In this way, the system applies the match criteria in a class map according to queue
priority (queue numbers closer to 0 have a lower priority).
To configure IP VLAN and DSCP match criteria in a Layer 3 class map, and apply the class and policy
maps to a service queue:
1. Create a match-any or a match-all Layer 3 class map, depending on whether you want the packets
to meet all or any of the match criteria. By default, a Layer 3 class map is created if you do not enter
the
layer2 option with the class-map command. When you create a class map, you enter the class-
map configuration mode.
CONFIGURATION mode
Dell(conf)#class-map match-all pp_classmap
2. Configure a DSCP value as a match criterion.
CLASS-MAP mode
Dell(conf-class-map)#match ipdscp 5
3. Configure an IP VLAN ID as a match criterion.
CLASS-MAP mode
Dell(conf-class-map)#match ip vlan 5
4. Create a QoS input policy.
CONFIGURATION mode
820
Quality of Service (QoS)

Table of Contents

Other manuals for Dell S4820T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell S4820T and is the answer not in the manual?

Dell S4820T Specifications

General IconGeneral
BrandDell
ModelS4820T
CategorySwitch
LanguageEnglish

Related product manuals