ipv6 address 1212::12/64
ipv6 nd dns-server 1000::1 1
ipv6 nd dns-server 3000::1 1
ipv6 nd dns-server 2000::1 0
no shutdown
Secure Shell (SSH) Over an IPv6 Transport
Dell Networking OS supports both inbound and outbound SSH sessions using IPv6 addressing. Inbound
SSH supports accessing the system through the management interface as well as through a physical
Layer 3 interface.
For SSH configuration details, refer to the Security chapter in the Dell Networking OS Command Line
Interface Reference Guide.
Configuration Tasks for IPv6
The following are configuration tasks for the IPv6 protocol.
• Adjusting Your CAM-Profile
• Assigning an IPv6 Address to an Interface
• Assigning a Static IPv6 Route
• Configuring Telnet with IPv6
• SNMP over IPv6
• Showing IPv6 Information
• Clearing IPv6 Routes
Adjusting Your CAM-Profile
Although adjusting your CAM-profile is not a mandatory step, if you plan to implement IPv6 ACLs, adjust
your CAM settings.
The CAM space is allotted in FP blocks. The total space allocated must equal 13 FP blocks. There are 16
FP blocks, but the System Flow requires three blocks that cannot be reallocated.
You must enter the ipv6acl allocation as a factor of 2 (2, 4, 6, 8, 10). All other profile allocations can use
either even or odd-numbered ranges.
The default option sets the CAM Profile as follows:
• L3 ACL (ipv4acl): 6
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
To have the changes take effect, save the new CAM settings to the startup-config (write-mem or copy
run start) then reload the system for the new settings.
512
IPv6 Routing
To Next Page
Loading...
Need help?
General