EasyManua.ls Logo

Dell S4820T - Redistributing Ipv4 Routes

Dell S4820T
1178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Applying IPv6 Routes
To apply prefix lists to incoming or outgoing IPv6 routes, use the following commands.
NOTE: These commands apply to IPv6 IS-IS only. To apply prefix lists to IPv4 routes, use ROUTER
ISIS mode, previously shown.
Apply a configured prefix list to all incoming IPv6 IS-IS routes.
ROUTER ISIS-AF IPV6 mode
distribute-list prefix-list-name in [interface]
Enter the type of interface and slot/port information:
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port
information.
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
For a port channel interface, enter the keywords port-channel then a number.
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Apply a configured prefix list to all outgoing IPv6 IS-IS routes.
ROUTER ISIS-AF IPV6 mode
distribute-list prefix-list-name out [bgp as-number | connected | ospf
process-id | rip | static]
You can configure one of the optional parameters:
connected: for directly connected routes.
ospf process-id: for OSPF routes only.
rip: for RIP routes only.
static: for user-configured routes.
bgp: for BGP routes only.
Deny RTM download for pre-existing redistributed IPv6 routes.
ROUTER ISIS-AF IPV6 mode
distribute-list redistributed-override in
Redistributing IPv4 Routes
In addition to filtering routes, you can add routes from other routing instances or protocols to the IS-IS
process. With the redistribute command syntax, you can include BGP, OSPF, RIP, static, or directly
connected routes in the IS-IS process.
NOTE: Do not route iBGP routes to IS-IS unless there are route-maps associated with the IS-IS
redistribution.
To add routes from other routing instances or protocols, use the following commands.
NOTE: These commands apply to IPv4 IS-IS only. To apply prefix lists to IPv6 routes, use ADDRESS-
FAMILY IPV6 mode, shown later.
Intermediate System to Intermediate System
549

Table of Contents

Other manuals for Dell S4820T

Related product manuals