ip address 1.1.1.1/24
ipv6 address 1abd::1/64
tunnel source 40.1.1.1
tunnel allow-remote 40.1.1.2
tunnel mode ipip decapsulate-any
no shutdown
Configuring Tunnel source anylocal Decapsulation
The tunnel source anylocal command allows a multipoint receive-only tunnel to decapsulate
tunnel packets addressed to any IPv4 or IPv6 (depending on the tunnel mode) address configured on the
switch that is operationally UP.
The source anylocal parameters can be used for packet decapsulation instead of the ip address or
interface (tunnel allow-remote command), but only on multipoint receive-only mode tunnels.
The following sample configuration shows how to use the tunnel source anylocal command.
Dell(conf)#interface tunnel 1
Dell(conf-if-tu-1)#ipv6 address 1abd::1/64
Dell(conf-if-tu-1)#ip address 1.1.1.1/24
Dell(conf-if-tu-1)#
tunnel source anylocal
Dell(conf-if-tu-1)#tunnel mode ipip decapsulate-any
Dell(conf-if-tu-1)#tunnel allow-remote 40.1.1.2
Dell(conf-if-tu-1)#no shutdown
Dell(conf-if-tu-1)#show config
!
interface Tunnel 1
ip address 1.1.1.1/24
ipv6 address 1abd::1/64
tunnel source anylocal
tunnel allow-remote 40.1.1.2
tunnel mode ipip decapsulate-any
no shutdown
1014
Tunneling