Example of the garp timer Command
Dell(conf)#garp timer leav 1000
Dell(conf)#garp timers leave-all 5000
Dell(conf)#garp timer join 300
Verification:
Dell(conf)#do show garp timer
GARP Timers Value (milliseconds)
----------------------------------------
Join Timer 300
Leave Timer 1000
LeaveAll Timer 5000
Dell(conf)#
Dell Networking OS displays this message if an attempt is made to configure an invalid GARP timer:
Dell(conf)#garp timers join 300 % Error: Leave timer should be >= 3*Join timer.
RPM Redundancy
The current version of Dell Networking OS supports 1+1 hitless route processor module (RPM)
redundancy.
The primary RPM performs all routing, switching, and control operations while the standby RPM monitors
the primary RPM. In the event that the primary RPM fails, the standby RPM can assume control of the
system without requiring a chassis reboot.
This section contains the following sub-sections:
• Boot the Chassis with a Single RPM
• Boot the Chassis with Dual RPMs
• Automatic and Manual RPM Failover
• Support for RPM Redundancy by Dell Networking OS Version
• RPM Synchronization
396
GARP VLAN Registration Protocol (GVRP)
To Next Page
Loading...
