Creating an ECMP Group Bundle
Within each ECMP group, you can specify an interface.
If you enable monitoring for the ECMP group, utilization calculation performs when the average
utilization of the link-bundle (as opposed to a single link within the bundle) exceeds 60%.
1. Create a user-defined ECMP group bundle.
CONFIGURATION mode
ecmp-group ecmp-group-id
The range is from 1 to 64.
2. Add interfaces to the ECMP group bundle.
CONFIGURATION ECMP-GROUP mode
interface interface interface tengigabitethernet 1/1 interface port-channel
100
3. Enable monitoring for the bundle.
CONFIGURATION ECMP-GROUP mode
link-bundle-monitor enable
Modifying the ECMP Group Threshold
You can customize the threshold percentage for monitoring ECMP group bundles.
To customize the ECMP group bundle threshold and to view the changes, use the following commands.
• Modify the threshold for monitoring ECMP group bundles.
CONFIGURATION mode
link-bundle-distribution trigger-threshold {percent}
The range is from 1 to 90%.
The default is 60%.
• Display details for an ECMP group bundle.
EXEC mode
show link-bundle-distribution ecmp-group ecmp-group-id
The range is from 1 to 64.
358
Equal Cost Multi-Path (ECMP)
To Next Page
Loading...
Need help?
General