Dell S4820T - Resolution of Host Names; Enabling Dynamic Resolution of Host Names

To view the configuration, use the show config command in INTERFACE mode.
Resolution of Host Names
Domain name service (DNS) maps host names to IP addresses. This feature simplifies such commands as
Telnet and FTP by allowing you to enter a name instead of an IP address.
Dynamic resolution of host names is disabled by default. Unless you enable the feature, the system
resolves only host names entered into the host table with the ip host command.
The following sections describe DNS and the resolution of host names.
• Enabling Dynamic Resolution of Host Names
• Specifying the Local System Domain and a List of Domains
• Configuring DNS with Traceroute
Name server, Domain name, and Domain list are VRF specific. The maximum number of Name servers
and Domain lists per VRF is six.
Enabling Dynamic Resolution of Host Names
By default, dynamic resolution of host names (DNS) is disabled.
To enable DNS, use the following commands.
• Enable dynamic resolution of host names.
CONFIGURATION mode
ip domain-lookup
• Specify up to six name servers.
CONFIGURATION mode
ip name-server ip-address [ip-address2 ... ip-address6]
The order you entered the servers determines the order of their use.
Example of the show hosts Command
To view current bindings, use the show hosts command.
Dell>show host
Default domain is force10networks.com
Name/address lookup uses domain service
Name servers are not set
Host Flags TTL Type Address
-------- ----- ---- ---- -------
ks (perm, OK) - IP 2.2.2.2
patch1 (perm, OK) - IP 192.68.69.2
tomm-3 (perm, OK) - IP 192.68.99.2
gxr (perm, OK) - IP 192.71.18.2
f00-3 (perm, OK) - IP 192.71.23.1
Dell>
486
IPv4 Routing