Dell S4820T - Debugging LLDP

Example of the multiplier Command to Configure Time to Live
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
no disable
R1(conf-lldp)#multiplier ?
<2-10> Multiplier (default=4)
R1(conf-lldp)#
multiplier 5
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
multiplier 5
no disable
R1(conf-lldp)#no multiplier
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
no disable
R1(conf-lldp)#
Debugging LLDP
You can view the TLVs that your system is sending and receiving.
To view the TLVs, use the following commands.
• View a readable version of the TLVs.
debug lldp brief
• View a readable version of the TLVs plus a hexadecimal version of the entire LLDPDU.
debug lldp detail
606
Link Layer Discovery Protocol (LLDP)