Dell S4820T User Manual

MIB Object OID Values Description
6 = timeout
7 = unknown
copyEntryRowStatus .
1.3.6.1.4.1.6027.3.5.1.1.1.
1.15
Row status Specifies the state of the
copy operation. Uses
CreateAndGo when you
are performing the copy.
The state is set to active
when the copy is
completed.
Obtaining a Value for MIB Objects
To obtain a value for any of the MIB objects, use the following command.
• Get a copy-config MIB object value.
snmpset -v 2c -c public -m ./f10-copy-config.mib force10system-ip-address
[OID.index | mib-object.index]
index: the index value used in the snmpset command used to complete the copy operation.
NOTE: You can use the entire OID rather than the object name. Use the form: OID.index.
Examples of Getting MIB Object Values
The following examples show the snmpget command to obtain a MIB object value. These examples
assume that:
• the server OS is UNIX
• you are using SNMP version 2c
• the community name is public
• the file f10-copy-config.mib is in the current directory
NOTE: In UNIX, enter the snmpset command for help using this command.
The following examples show the command syntax using MIB object names and the same command
using the object OIDs. In both cases, the same index number used in the snmpset command follows the
object.
The following command shows how to get a MIB object value using the object name.
> snmpget -v 2c -c private -m ./f10-copy-config.mib 10.11.131.140
copyTimeCompleted.110
FTOS-COPY-CONFIG-MIB::copyTimeCompleted.110 = Timeticks: (1179831) 3:16:38.31
The following command shows how to get a MIB object value using OID.
> snmpget -v 2c -c private 10.11.131.140 .1.3.6.1.4.1.6027.3.5.1.1.1.1.13.110
SNMPv2-SMI::enterprises.6027.3.5.1.1.1.1.13.110 = Timeticks: (1179831)
3:16:38.31
942
Simple Network Management Protocol (SNMP)

Dell S4820T Specifications

General

Brand	Dell
Model	S4820T
Category	Switch
Language	English