Dell S4820T User Manual

CLI Command Mode Prompt Access Command
LLDP Dell(conf-lldp)# or
Dell(conf-if—interface-
lldp)#
protocol lldp
(CONFIGURATION or INTERFACE
Modes)
LLDP MANAGEMENT INTERFACE
Dell(conf-lldp-mgmtIf)#
management-interface (LLDP
Mode)
LINE
Dell(config-line-console)
or Dell(config-line-vty)
line console orline vty
MONITOR SESSION
Dell(conf-mon-sess-
sessionID)#
monitor session
OPENFLOW INSTANCE
Dell(conf-of-instance-of-
id)#
openflow of-instance
PORT-CHANNEL FAILOVER-
GROUP
Dell(conf-po-failover-
grp)#
port-channel failover-
group
PRIORITY GROUP
Dell(conf-pg)# priority-group
PROTOCOL GVRP
Dell(config-gvrp)# protocol gvrp
QOS POLICY
Dell(conf-qos-policy-out-
ets)#
qos-policy-output
VLT DOMAIN
Dell(conf-vlt-domain)# vlt domain
VRRP
Dell(conf-if-interface-
type-slot/port-vrid-vrrp-
group-id)#
vrrp-group
u-Boot
Dell=>
Press any key when the following
line appears on the console
during a system boot: Hit any
key to stop autoboot:
UPLINK STATE GROUP
Dell(conf-uplink-state-
group-groupID)#
uplink-state-group
The following example shows how to change the command mode from CONFIGURATION mode to
PROTOCOL SPANNING TREE.
Example of Changing Command Modes
Dell(conf)#protocol spanning-tree 0
Dell(config-span)#
Configuration Fundamentals
43

Dell S4820T Specifications

General

Brand	Dell
Model	S4820T
Category	Switch
Language	English