Delta Electronics AC Motor Drive VFD-VE Series - Page 114

Chapter 4 Parameters|
Revision August 2008, 03VE, SW V2.04 4-65
Settings Functions Descriptions
35 Enable position control
When this function is enabled, the AC motor drive will start to
execute position control.
10-00
10-01
RUN
MI=d35
MO=d39
10-19
PG
Feedback
Motor
Frequency
Time
10-00
10-01
RUN
MI=d35
MO=d39
10-19
RUN
RUN
Motor
frequency
PG
feedback
Time
36
Enable position learning
function (valid at stop)
When this function is enabled, it will select the corresponding
multi-position by the ON/OFF status of multi-function inputs 1-
4 and written the current motor position into the corresponding
multi-position.