DA 62 AFM Airplane Description
Annunciation of the flight director and autopilot modes is shown in the lower status field
of the PFD. In general, green indicates active modes and white indicates armed modes.
When a mode is directly selected by the pilot, no flashing of the mode will occur. When
automatic mode changes occur, they will be annunciated with a flashing annunciation
of the new mode for ten seconds in green. If a mode becomes unavailable for whatever
reason, the mode will flash for ten seconds in yellow and be replaced by the new mode
in green.
Normal autopilot disconnects are annunciated with a yellow flashing AP on the PFD
accompanied by a two second autopilot disconnect tone. Normal disconnects are those
initiated by the pilot with the AP DISC switch, the MET switch, the AP button on the MFD
mode controller, or the GA button (if ESP/USP is NOT installed). Abnormal disconnects
will be accompanied by a red flashing AP on the PFD accompanied by a continuous
autopilot disconnect tone. The disconnect tone and flashing alert may be cancelled by
pressing the AP DISC switch or the left side of the MET switch.
Refer to the Garmin G1000 Cockpit Reference Guide, P/N 190-01896-( ), and Garmin
G1000 Pilot's Guide for the Diamond DA 62, P/N 190-01895-( ), for complete descriptions
of the G1000 system and operating procedures.
If MÄM 62-254 is installed, refer to the Garmin G1000 NXi Cockpit Reference Guide,
P/N 190-01905-( ) and Garmin G1000 NXi Pilot's Guide for the Diamond DA 62,
P/N 190-01904-( ) for complete descriptions of the G1000 NXi system and operating
procedures.
Doc. No. 11.01.05-E Rev. 0 11-Jan-2019 Page 7 - 89
To Next Page
Loading...
