DA20-C1 Flight Manual
Supplement 3
Doc # DA202-C1 April 16, 2009 Page S3 - 2
1. GENERAL
The installation is defined by Service Bulletin DAC1-33-01.
2. OPERATING LIMITATIONS
2.15. PLACARDS
1. On the instrument panel above the individual circuit breakers
Figure 1.
3. EMERGENCY PROCEDURES
There are no changes to the airplane emergency procedures when the Recognition Lights are
installed.
4. NORMAL PROCEDURES
Pulsing the landing/taxi lights enhances the aircraft flight path recognition quality and may be
used any time the pilot desires. It is recommended that the landing lights be turned on steady
rate when the aircraft is within 200' AGL at night.
NOTE
Pulsing should not be used when operating near clouds or on the
ground.
5. PERFORMANCE
There is no change in airplane performance with the Recognition Lights installed.
6. WEIGHT AND BALANCE
The Recognition Lights installation adds 2.5 lbs (1.13 kg) of weight at a 0 in (0 m) moment arm.
Revision 24 DOT Approved
To Next Page
Loading...
