DA20-C1 Flight Manual
Supplement 1
Doc # DA202-C1 April 16, 2009 Page S1 - 7
Revision 24 DOT Approved
Starting Engine
The Starting Engine checklist from Section 4.4.3 is repeated in this section and includes the
steps for starting the engine with an external power source connected.
4.4.3. Starting Engine
A. Starting Engine Cold
NOTE
It is recommended that the engine be preheated if it has been cold
soaked for 2 hours or more at temperatures of -4º C (25º F) or
less.
1. Throttle IDLE
2. Mixture FULL RICH
3. Toe Brakes hold
4. Propeller Area clear
WARNING
ENSURE THAT PROPELLER AREA IS CLEAR!
CAUTION
DO NOT ENGAGE STARTER IF PROPELLER IS MOVING.
SERIOUS ENGINE DAMAGE CAN RESULT
NOTE
Steps 5, 6, 7, 8 and 9 are to be performed without delay between
steps.
NOTE
Colder ambient temperatures require longer priming
5. Fuel Pump ON
6. Fuel Prime ON
To Next Page
Loading...
