Diamond DA20-C1 - Altitude Hold Mode; Before Take-Off; Cruise (S-Tec); Landing Approach (S-Tec)

DA20-C1 Flight Manual Supplement 5
Doc # DA202-C1 April 16, 2009 Page S5 - 6
Revision 24 DOT Approved
4.4.6. Before Take-off
22a. Autopilot Disengaged (AP DISC)
4.4.9. Cruise
Insert after
6. Engine Gauges check
7. Autopilot Operation (if desired)
NOTE
A guide containing useful operating information is available from
S-TEC Corporation, One S-TEC Way, Municipal Airport, Mineral
Wells, Texas, 76067-9236, USA. The Guide, P/N 8777, is titled
Pilots Operating Handbook, “System Twenty, System Thirty,
System Thirty ALT, Autopilots”
ROLL MODE
1. Check Autopilot Master ON
2. Mode Select Switch Select desired roll mode
ALTITUDE HOLD MODE
1. Check Autopilot Master ON
NOTE
The aircraft should be trimmed for level flight prior to “Altitude Hold
Engagement”.
2. ALT ENG / DISENG PRESS
3. Trim “UP”, trim “DN” annunciators MONITOR
4.4.11. Landing Approach
1. Autopilot Disengaged (AP DISC)