DA20-C1 Flight Manual
Normal Operating Procedures
Doc # DA202-C1 April 16, 2009 Page 4 - 5
4.4. NORMAL OPERATION CHECKLIST
4.4.1. Preflight Inspection
A. In-Cabin Check
1. Structural Temperature Indicator check that Structural Temperature
(if OAT exceeds 38º C (100º F)) does not exceed 55º C (131º F)
2. Airplane Documents check
3. Flight Control Lock removed
4. Flight Controls check for proper direction of
movement
5. Ignition Key pulled out
6. Cabin Heat free
7. Parking Brake free
8. Throttle free, IDLE
9. Mixture free, IDLE CUTOFF
10. GEN/BAT Master Switch ON
11. Warning Lights (Gen. and Canopy) illuminated
12. Fuel Quantity sufficient
13. Engine Gauges, Ammeter and check
Voltmeter
14. Circuit Breakers pressed in
15. Map Light operational
16. Instrument Lights operational and dimmable
17. Trim NEUTRAL
18. Wing Flaps (Indicator- and check, extend and retract fully
Flap Actuation)
19. Trim and Flap Indicator Lights operational and dimmable
20. Exterior Lights operational as required
21. GEN/BAT Master Switch OFF
22. Foreign Object Inspection done
23. Emergency Locator Transmitter (ELT):
ARTEX ELT-200 ARM
EBC Model 502 - ARM
EBC Model 102A - OFF
ARTEX ME 406 ARM
24. Fire Extinguisher check
25. Rescue Hammer check
26. Baggage stowed, baggage net attached
27. Canopy clean, undamaged
Revision 24 DOT Approved
To Next Page
Loading...
