DA20-C1 Flight Manual
Normal Operating Procedures
Doc # DA202-C1 April 06, 2010 Page 4 - 14
Revision 25 DOT Approved
4.4.6. Before Take-off (Engine Run-up)
NOTE
For OAT’s less than -5º F (-20º C) turn cabin heat on for at least
10 minutes prior to take-off.
1. Brakes apply
2. Safety Belts fastened
3. Canopy closed and locked
4. Canopy Unlock Warning Light OFF
5. Fuel Pressure check
6. Fuel Shut-off Valve check OPEN
7. Fuel Quantity Indicator check
8. Fuel Prime check OFF
9. Fuel Pump check ON
10. Trim NEUTRAL
11. Flight Controls free
12. Oil Temp. 75º minimum
13. Mixture FULL RICH
14. Throttle 1700 RPM
15. Magneto Check Cycle L - BOTH - R – BOTH (RPM
drop: 25-150 RPM) (Max. RPM
difference (L/R): 50 RPM)
16. Mixture check
17. Alt. Load check
18. Oil Pressure 30-60 psi
19. Vacuum Gauge (if installed) within green range
20. Throttle IDLE (975 RPM Minimum, for
aircraft with altitude compensating
fuel system)
21. Mixture Move slowly toward lean cut off
(RPM increase) (50 RPM Minimum,
for aircraft with altitude
compensating fuel system)
22. Mixture FULL RICH
23. Circuit Breakers check pressed IN
24. Wing Flaps T/O
25. Parking Brake release
To Next Page
Loading...
