Interfaces Wide Area Networks (WANs)
AnywhereUSB® Plus User Guide
131
1. Log into the AnywhereUSB Plus WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Configure active recovery on ETH1:
a. Click Network > Interface > ETH1 > IPv4 > SureLink.
b. For Interval, type 10s.
c. Click to expand Test targets.
d. Delete the existing test targets:
Click the menu icon (...) next to each target and select Delete.
e. For Add Test Target, click g.
f. For Test type, select Ping test.
g. For Ping host, type 43.66.93.111.
h. For Ping payload size, type 256.
4. Repeat the above step for Modem to enable SureLink on that interface.
5. Click Apply to save the configuration and apply the change.
To Next Page
Loading...
