Digi AnywhereUSB Plus User Manual

Interfaces Wide Area Networks (WANs)
AnywhereUSB® Plus User Guide
132
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure SureLink on ETH1:
a. Set the interval to ten seconds:
(config)> network interface eth1 ipv4 surelink interval 10s
(config)>
b. Delete the existing test targets:
(config network interface eth1> del ipv4 surelink target 0
(config network interface eth1> del ipv4 surelink target 1
(config network interface eth1)>
c. Add a test target:
(config)> add network interface eth1 ipv4 surelink target end
(config network interface eth1 ipv4 surelink target 0)>
d. Set the probe type to ping:
(config network interface eth1 ipv4 surelink target 0)> test ping
(config network interface eth1 ipv4 surelink target 0)>
e. Set the packet size to 256 bytes:
(config network interface eth1 ipv4 surelink target 0)> ping_size 256
(config network interface eth1 ipv4 surelink target 0)>
f. Set the host to ping:
(config network interface eth1 ipv4 surelink target 0)> ping_host
43.66.93.111
(config network interface eth1 ipv4 surelink target 0)>
1. Repeat the above step for the cellular Modem (modem) interface to enable SureLink on that
interface.

Digi AnywhereUSB Plus Specifications

General

Brand	Digi
Model	AnywhereUSB Plus
Category	Switch
Language	English