Services Location information
AnywhereUSB® Plus User Guide
257
n
To limit access based on firewall zones:
a. Click Zones.
b. For Add Zone, click g.
c. For Zone, select the appropriate firewall zone from the dropdown.
See Firewall configuration for information about firewall zones.
d. Click gagain to allow access through additional firewall zones.
9. Click Apply to save the configuration and apply the change.
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a location source:
(config)> add service location source end
(config service location source 0)>
4. (Optional) Set a label for this location source:
(config service location source 0)> label "label"
(config service location source 0)>
5. Set the type of location source to server:
(config service location source 0)> type server
(config service location source 0)>
6. Set the UDP port that will receive incoming location messages.
(config service location source 0)> server port port
(config service location source 0)>
7. Click Access control list to configure access control:
n
To limit access to specified IPv4 addresses and networks:
(config)> add service location source 1 acl address end value
(config)>
Where value can be:
To Next Page
Loading...
Need help?
General