Digi AnywhereUSB Plus

Revision Date Description
n
Added ability to override or edit SSH server options.
n
Added options for filtering Wi-Fi scanner results based off of MAC
addresses or RSSI signal strength.
n
Added options for sending local device event logs to Digi Remote
Manager.
n
New system time CLI command for manually setting the local
date and time.
n
New firewall packet filter options to allow/deny packets based off
of a range of source or destination MAC addresses.
n
New monitoring metrics upload CLI command to send on-
demand health metrics to Digi Remote Manager.
n
Added support for the configuration of custom scripts that will be
run manually, and a new system script start CLI command to
run manual scripts.
n
Added datapoint.upload_multiple function to digidevice python
module for uploading multiple datapoints to DigiRM at once.
n
Added clear dhcp-lease command to remove all dynamic DHCP
leases or certain DHCP leases based on MAC address or IP
address.
n
Added speedtest command for performing on-demand iPerf or
nuttcp speedtests.
n
Local users are now required to be assigned to an authentication
group.
n
New Network → Advanced → Sequential DHCP address allocation
configuration setting for controlling if DHCP addresses are
assigned sequentially or randomly (disabled by default).
n
Added ability to control if DHCP addresses are assigned
sequentially or randomly (disabled by default).
n
Added 802.1x port-based network access control, configurable
per network interface.
L July 2021
Added Safety warnings.
Updated Change the client ID.
Added complete section Interfaces.
AnywhereUSB® Plus User Guide
3